610A Four Channel Control Module for Combustible Gas Applications. While the 610A system is easy to install and operate, this manual should be read in full and the information contained herein understood before attempting to place the system in service. The safety products you have purchased should be handled carefully and installed. View and Download Macurco GD-6 user instructions online. Combustible Gas Detector, Controller and Transducer. GD-6 Security Sensors pdf manual download. The Natural Gas Detector is a low voltage electronic detector of natural gases. SPST Alarm Relay and N.C. SPST Trouble relay to connect to Alarm Control Panels. And aerosol propellants (aerosol cans such as hair spray usually contain a combustible gas) may cause alarms. Do NOT mount it where the normal ambient temperature.
- User Manual For Vt310 Combustible Gas Alarm Controller Free
- Combustible Gas List
- List Of Combustible Gases
IMPORTANT
Be sure to read and understand the entire
instruction manual before installing, operating or
servicing the gas detection equipment.
WARNING
Do not open the transmitter enclosure with power
applied unless it is verified that no combustible
gases or vapors are present. A portable gas
detection instrument should be used to ensure
that the area is clear of any combustible gases.
Calibration or maintenance should not be
performed if there is any indication of the presence
of combustible gas at the sensor.
WARNING
It is possible for the transmitter output to drop to
a low LFL level after going into high alarm and
still have a dangerous level of combustible gas
present. Therefore, precautions should be taken to
ensure that the combustible gas has been cleared
before considering the area safe.
WARNING
The sintered metal flame arrestor is an integral
part of the combustible gas sensor. DO NOT
operate the gas detector if the flame arrestor is
damaged or missing, since the exposed element is
a potential ignition source.
CAUTION
To ease installation and future removal, ensure
that all junction box covers and sensor threads
are properly lubricated. If the need arises for
additional lubrication, use either Lubriplate grease
(P/N 102868-001) or Teflon tape for sensor threads.
Avoid the use of silicone grease.
User Manual For Vt310 Combustible Gas Alarm Controller Free
CAUTION
The wiring instructions in this manual will provide
safe and proper functioning of the device under
normal conditions. However, local variations in
wiring codes and regulations exist, and total
compliance with these ordinances cannot be
guaranteed. Be certain that all wiring complies
with the IEC/NEC as well as all local ordinances.
If in doubt, consult the local authority having
jurisdiction before wiring the system.
NOTE
Throughout this manual, the device receiving the
output signal from the transmitter will be referred
to as the “controller.” A typical controller provides
a visual display of the % LFL output from the
monitored transmitter, indicators for alarm and
trouble conditions, and outputs for controlling
response devices. Other control systems are also
compatible with the Model 505.
Safety Messages
i